BB reissue board install

Info about our boards and kits.

Moderator: VelvetGeorge

Post Reply
knable
New Member
Posts: 2
Joined: Tue Oct 23, 2007 4:55 pm

BB reissue board install

Post by knable » Thu May 15, 2008 7:13 pm

i have installed the board in the chassis and channel 2 sounds amazing, however, channel 1 sounds weak up to 8 on volume then sounds like an electronic meltdown. also when jumpered, channel 1 completely takes over. have gone through schematic and can't figure it out. local amp tech couldn't either, so you obi wans are my only hope. any advice.

User avatar
Wicksy
Senior Member
Posts: 972
Joined: Mon Nov 21, 2005 9:42 am
Location: Halstead, Essex, UK

Post by Wicksy » Fri May 16, 2008 7:04 pm

Can you post a few pictures of the amp innards?
Simon

Post Reply