2203 trouble shooting help needed
Posted: Wed Jan 04, 2012 12:03 am
Power switch was bad. I jumped the switch and all powers up fine with good heater voltage, B+, etc BUT NO input signal except for a slight hum. Some funky voltages but I can't pinpoint it. Biggest question is "0" volts at V2 pin 3 (s/b 1.1).
OK super sleuth's, see anything I'm missing?? Weird thing is the hot lead from the input jack to V1 pin 2 checks as continuity to ground. I think the problem is in there but it's wired per the instructions and my brain is getting too fuzzy to dupe it out.
OK super sleuth's, see anything I'm missing?? Weird thing is the hot lead from the input jack to V1 pin 2 checks as continuity to ground. I think the problem is in there but it's wired per the instructions and my brain is getting too fuzzy to dupe it out.