Resistors on screen cans?
Posted: Wed May 17, 2017 2:37 pm
I have two, 330k 2watt resistors to go on the screen cans but there is about ten ohms difference between them. Would this matter?
I'd read in one of George's posts as well as I think in the evolution of the plexi circuit thread that 220k or higher would be better than the stock 56k.
I have some 470k, 2 watt. Would those be too big for the job or are they ok?
I'd read in one of George's posts as well as I think in the evolution of the plexi circuit thread that 220k or higher would be better than the stock 56k.
I have some 470k, 2 watt. Would those be too big for the job or are they ok?