Page 1 of 1
1 ohm bias resistors
Posted: Thu Jul 14, 2005 10:15 am
by OnTheFritz
I'm slowly plugging along on a 100 watt re-build, and was getting ready to solder in the aforementioned biasing resistors, and they measure:
1.4, 1.3, 1.3, and 1.3. Should i even bother? My readings are gonna be way out of whack, right?
Fritz
Posted: Thu Jul 14, 2005 11:22 am
by VelvetGeorge
Most metes are not very accurate at those low resistances. Do you think your readings are right?
George
Posted: Thu Jul 14, 2005 11:28 am
by OnTheFritz
Now that you say that, I'm not sure, it's a cheap meter!
I think I'll put em' in, and just wing it, and keep an eye out for any redplating.
Thanks,
Fritz
Posted: Thu Jul 14, 2005 11:30 am
by 5150loveeddie
An other thing when the amp gets hot the resistors itseft will become not acurate so better do your biasing before it get to hot in there!!!!!