Connecting the Lar/Mar in a Bugera 1960
Moderator: VelvetGeorge
- tshodges
- New Member
- Posts: 17
- Joined: Sat Jul 30, 2011 9:45 pm
- Just the numbers in order: 7
Re: Connecting the Lar/Mar in a Bugera 1960
Can I cut the traces right at all Pin 5's?
Last edited by tshodges on Wed Jan 02, 2013 3:58 pm, edited 3 times in total.
-
- Senior Member
- Posts: 675
- Joined: Mon Mar 19, 2012 1:07 pm
- Just the numbers in order: 13492
- Location: Finland
Re: Connecting the Lar/Mar in a Bugera 1960
If you are soldering the wires from the pot directly to the pins then yes you can cut the traces. Remember to have jumper to connect V4 and V5 grids and V6 and V7 grids together. If the bugera doesn't have, then it would be good if you also installed 5.6k swamp resistors directly on all power tube grids to avoid oscillation.
- tshodges
- New Member
- Posts: 17
- Joined: Sat Jul 30, 2011 9:45 pm
- Just the numbers in order: 7
Re: Connecting the Lar/Mar in a Bugera 1960
Awesome, everything should be done! I'll post pics shortly!
Last edited by tshodges on Wed Jan 02, 2013 4:00 pm, edited 1 time in total.
-
- Senior Member
- Posts: 675
- Joined: Mon Mar 19, 2012 1:07 pm
- Just the numbers in order: 13492
- Location: Finland
Re: Connecting the Lar/Mar in a Bugera 1960
Definitely post some pics, this thread will be helpful to other people with the older bugera too.
Oh, and remember to take all the power tubes out before measuring. ALL pin 5s of the power tubes MUST have NEGATIVE dc voltage on them. If you don't get negative dc on all the grids don't put the power tubes in.
Oh, and remember to take all the power tubes out before measuring. ALL pin 5s of the power tubes MUST have NEGATIVE dc voltage on them. If you don't get negative dc on all the grids don't put the power tubes in.
-
- Senior Member
- Posts: 608
- Joined: Tue Mar 07, 2006 11:30 pm
Re: Connecting the Lar/Mar in a Bugera 1960
Where's the pics?
-
- New Member
- Posts: 1
- Joined: Fri Jul 05, 2013 5:38 am
- Just the numbers in order: 13492
Re: Connecting the Lar/Mar in a Bugera 1960
Good Questionplanetjimi wrote:Where's the pics?
-
- New Member
- Posts: 7
- Joined: Tue Dec 06, 2016 12:45 am
- Just the numbers in order: 13492
Re: Connecting the Lar/Mar in a Bugera 1960
Does ANYONE have pics of this connected to the pcb?