1 ohm bias resistors

OnTheFritz · Post by **OnTheFritz** » Thu Jul 14, 2005 10:15 am

I'm slowly plugging along on a 100 watt re-build, and was getting ready to solder in the aforementioned biasing resistors, and they measure:
1.4, 1.3, 1.3, and 1.3. Should i even bother? My readings are gonna be way out of whack, right?

Fritz

Post by **VelvetGeorge** » Thu Jul 14, 2005 11:22 am

Most metes are not very accurate at those low resistances. Do you think your readings are right?

George

OnTheFritz · Post by **OnTheFritz** » Thu Jul 14, 2005 11:28 am

Now that you say that, I'm not sure, it's a cheap meter!
I think I'll put em' in, and just wing it, and keep an eye out for any redplating.
Thanks,
Fritz

5150loveeddie · Post by **5150loveeddie** » Thu Jul 14, 2005 11:30 am

An other thing when the amp gets hot the resistors itseft will become not acurate so better do your biasing before it get to hot in there!!!!!