How to wire up the bias pot?
Posted: Wed Jul 18, 2012 2:00 am
The bias pot I've got is a horizontal mounted one with 4 legs. From what I've seen on pics, where the 2 legs on top go is clear, but it was hard to see anything going on on the bottom. So,
1. Does each of the bottom 2 legs of the bias pot go to each of the bias caps' ends/terminals?
2. Regardless of the above question, do I need a buss wire connecting the bias caps' terminals?
Thanks!
1. Does each of the bottom 2 legs of the bias pot go to each of the bias caps' ends/terminals?
2. Regardless of the above question, do I need a buss wire connecting the bias caps' terminals?
Thanks!