O100JM Tone Clone Chassis holes don't match?
Moderator: VelvetGeorge
-
wrea398
- Senior Member
- Posts: 649
- Joined: Thu Nov 26, 2009 10:06 am
- Just the numbers in order: 7
O100JM Tone Clone Chassis holes don't match?
I have a 67-68 chassis from Metroamp and just received my Tone Clone O100JM tranny. The installation holes dont line up. The chassis holes are narrow and when bolts are installed on one side, the other two brackets cover up the holes. Any others have the same issue? I just hate drilling out holes etc. Thanks!
-
novosibir
- Senior Member
- Posts: 4654
- Joined: Tue Nov 22, 2005 2:32 pm
- Just the numbers in order: 7
- Location: Nuernberg, Germany
- Contact:
Re: O100JM Tone Clone Chassis holes don't match?
MM, Heyboer and British made trannies do have different end bells and different foot prints.
It's impossible, to make a chassis, where they all fit. This would require holes of 3/4 inch dia. and mounting washers of 2 inch dia.
Larry
It's impossible, to make a chassis, where they all fit. This would require holes of 3/4 inch dia. and mounting washers of 2 inch dia.
Larry
The fault almost always is sitting in front of the amp 
Larry's Website now with included Pix's Gallery
Larry's Website now with included Pix's Gallery
-
LJay942
- Senior Member
- Posts: 286
- Joined: Sun Aug 16, 2009 1:13 am
- Just the numbers in order: 13492
- Location: Iowa
Re: O100JM Tone Clone Chassis holes don't match?
Yup they don't fit. I had to drill holes on mine. It's not too bad just make marks with a Sharpie and go to town 