OPT mounting/ lop-sided marshall
Moderator: VelvetGeorge
-
- Senior Member
- Posts: 1304
- Joined: Sat Jan 21, 2006 9:17 pm
- Just the numbers in order: 13492
OPT mounting/ lop-sided marshall
Is there any reason why the OPT in a superlead couldn't be mounted towards the other end of the chassis to balance the weight better?
- Flames1950
- Senior Member
- Posts: 9294
- Joined: Sun Feb 08, 2004 1:04 am
- Location: Waukee, Iowa
-
- Senior Member
- Posts: 1304
- Joined: Sat Jan 21, 2006 9:17 pm
- Just the numbers in order: 13492
I'll have to see if the wires on my trannys are long enough to run the length of the chassis like hiwatts. I assume there's no other noise issues or problems with this differnt wiring rout for the OPT? or did hiwatt do extra shielding or take extra steps to deal with the location?
http://acplink.com/search_results.aspx?msrch=Hiwatt
http://acplink.com/search_results.aspx?msrch=Hiwatt
- Flames1950
- Senior Member
- Posts: 9294
- Joined: Sun Feb 08, 2004 1:04 am
- Location: Waukee, Iowa
I've not looked in depth into HiWatt wiring yet, although I'd like to build a clone sometime. But they were neat, clean and bulletproof so they are going to be a good guide if you can find detailed pics.
Was it Mark Huss that built a HiWatt clone and had a web page detailing it I think? Might search for that and see if it had layouts........
Was it Mark Huss that built a HiWatt clone and had a web page detailing it I think? Might search for that and see if it had layouts........