Hey guys.
Lokking at the 8 ohm resistor + 1 mH inductor:
If I removed the inductor ( L1 ), wound it be wrong for the load? Is the inductor a part of the load, and needs to be calculated into the load?
Ralle
One question about the Power Brake...
Moderator: VelvetGeorge
-
Ralle
- Senior Member
- Posts: 1565
- Joined: Fri Feb 23, 2007 5:23 am
-
Ralle
- Senior Member
- Posts: 1565
- Joined: Fri Feb 23, 2007 5:23 am
Re: One question about the Power Brake...
Over 40 wiews and no reply... this must be a hard nut to crack...
-
SteadyEddie
- Senior Member
- Posts: 1035
- Joined: Wed Jul 07, 2010 11:55 pm
- Just the numbers in order: 7
Re: One question about the Power Brake...
I took a quick look at it. It seems that the inductor acts as some sort of filter for the load?
Why would you want to remove it?
Why would you want to remove it?
-
Ralle
- Senior Member
- Posts: 1565
- Joined: Fri Feb 23, 2007 5:23 am
Re: One question about the Power Brake...
I would like to see if the load changes without the inductor in this particular circut...would the load in the powerbrake still be the same ( I know that the highs will go away, but that's not the point here )... Can I still use it the same way, without any adjustments?