Hey guys,
I picked up some of those blue BC 330uf/25V electrolyitcs from george to use as bypass caps.
There is one end of the cap that has a single black stripe on it close to the end. Is this the negative side of the cap?
There is a + almost midway on the cap body.
He has pics is the store.
Thanks,
Mark
330uf/25V BC bypass caps from George, how is polarity marked
Moderators: VelvetGeorge, RACKSYSTEMS
-
- Senior Member
- Posts: 1673
- Joined: Mon May 08, 2006 8:28 pm
- Location: chicago, IL
-
- Senior Member
- Posts: 1673
- Joined: Mon May 08, 2006 8:28 pm
- Location: chicago, IL
Thanks Mark that would means the single stripe indicates negative side then. Thanks so much I am getting closer to firing up my 72 with the type II master.
Mark I think I got the my mind around everything.
The ground wire from the shielded wire is grounded to the pot housing backside or the left lug looking at the pot backside? The drawing looks like it is connected to the lug that is coming in from the bias supply just how the lines cross on the drawing.
I would guess the pot housing correct for the shielded ground.
Thanks much!
Mark I think I got the my mind around everything.
The ground wire from the shielded wire is grounded to the pot housing backside or the left lug looking at the pot backside? The drawing looks like it is connected to the lug that is coming in from the bias supply just how the lines cross on the drawing.
I would guess the pot housing correct for the shielded ground.
Thanks much!
- rockstah
- Senior Member
- Posts: 12481
- Joined: Thu Sep 15, 2005 12:28 pm
- Just the numbers in order: 7
- Location: Austin Texas
uh i figured it was totally clear in the layout.harddriver wrote:Thanks Mark that would means the single stripe indicates negative side then. Thanks so much I am getting closer to firing up my 72 with the type II master.
Mark I think I got the my mind around everything.
The ground wire from the shielded wire is grounded to the pot housing backside or the left lug looking at the pot backside? The drawing looks like it is connected to the lug that is coming in from the bias supply just how the lines cross on the drawing.
I would guess the pot housing correct for the shielded ground.
Thanks much!
not grounded to the housing of the pot. ground to the left lug in the picture. and yes the bias supply yada yada - just like the picture!
im sure Larry will give more details on it.

-
- Senior Member
- Posts: 1673
- Joined: Mon May 08, 2006 8:28 pm
- Location: chicago, IL