Metropoulos Forum

Posted: **Mon Jul 20, 2015 12:00 am**

Hi guys! I'm planning on building a patchbox for my pedalboard (simple guitar to pedals/pedals to amp & FX loop send/return w/switchable in/out buffers) and I was wondering if I could use a standard XLR cable for the fx loop to save on space and cable? I could use Pin1 for ground and the other 2 for the send & return... Will it add noise to my setup since both cable are so close togheter???

Or maybe I'm better off with two separate 1/4 in cables?

Thanks!

Posted: **Mon Jul 20, 2015 9:14 pm**

Hello and welcome pardner.

George uses a 5 pin on his bad arse MetroPlex :

Posted: **Mon Jul 20, 2015 9:55 pm**

JimiJames wrote:Hello and welcome pardner.

George uses a 5 pin on his bad arse MetroPlex :

Hi! Thanks for the answer but that's for a footswitch, I'm talking about an effect loop though. Thanks for the help though

Posted: **Mon Jul 20, 2015 10:58 pm**

Metropoulos Forum

XLR cable for fx loop?

XLR cable for fx loop?

Re: XLR cable for fx loop?

Re: XLR cable for fx loop?

Re: XLR cable for fx loop?